Radium Fuel Cell Vent Kit 12An

Radium Engineering Fuel Cell Vent Kit 12An.This high flow kit is typically used for quick-fill systems that commonly use a dry break and dump can. It includes an air filter, 6ft (1.8m) of 3/4" ID fuel vent hose, and adapter fittings. The kit requires a 12AN male vent fitting.
NOTE: This can be used with Radium 20-0462 DSV, 12AN ORB to 12AN Male, Quick Fill.

Important steps to properly route the vent line and prevent unwanted fuel loss:
1. From the fuel cell, the hose must first run upwards allowing any fuel captured in the vent line to drain back down into the cell.
2. After ascending vertically, the line should briefly route towards the front of the vehicle to prevent fuel from sloshing out.
3. Vertical loops should be added to act as a "make-shift" expansion chamber. This allows air to escape and any fuel to drop to the bottom of the loops.
4. Depending on the application, the overall vertical height of the vent hose should be at least 12".
5. For remote fuel fill applications, the vertical loops must be higher than the fill point.
6. The vent hose should terminate outside of the cabin, below and behind the fuel cell and away from the exhaust system.